This is a tough black rubber similar in feel to a car tire. It is used not only for making concrete or cement molds and stamps, but also for making hard durable rubber parts for machinery or automotive applications.
This one to one
mix ratio polyurethane rubber is used for making molds for concrete and/or cement. The smallest container in
the picture contains a mold release, and is included with each small kit.
You must mix, apply and cure AeroMarine Products Concrete Molding and Stamping Rubber in a humidity-controlled environment. Please contact us at 1.877.342.8860 should you have any questions.
AeroMarine Concrete
Molding and Stamping Rubber Price Page
AeroMarine Concrete
Molding and Stamping Rubber
1/2 gallon kit, makes 1/2 gallon, includes mold release
$38.00
Ships Immediately
AeroMarine Concrete
Molding and Stamping Rubber
2 gallon kit, makes two gallons, includes mold release
$118.00
Ships Immediately
AeroMarine Concrete
Molding and Stamping Rubber
ten gallon kit, makes ten gallons, does not include mold release
$468.00
Ships Immediately
AeroMarine Concrete
Molding and Stamping Rubber
drum kit, makes 110 gallons, does not include mold release
$3570.00
Call to place order
These
freight rates apply to the lower 48 states. Freight
outside this area will be more expensive. For more information or
for custom rate quotes, please call us at (877)342-8860 to determine the most
efficient method for you to receive your products.
Most orders are shipped within 24 hours. Please note: Weekend orders are shipped on
Monday. This product ships D.O.T. Non-Regulated. Thus, there are no
hazardous material fees involved.
Properties
Mixed Viscosity
Thin liquid
Mix Ratio
1 :1 by volume
Pot Life,
minutes @ 77ºF
5
Cure time, hours @77ºF
12
Tensile strength
750psi
Color
Black
Shrinkage
negligible
Durometer
75 shore A
Elongation at break
500%
Molded Concrete Birdbath
AeroMarine concrete molding and stamping rubber is a
tough rubber that resembles a rubber shoe heel
Instructions for AeroMarine Products' Concrete Molding and Stamping Rubber
Use between 65° and 75°F. Mix parts “A” (black)
and “B” (clear) very thoroughly until a consistent black color is achieved. Pour within 5
minutes of mixing.
A mold release must be used when pouring AeroMarine's Concrete Mold and Stamping Rubber against
another surface. AeroMarine Products' Mold Release (sold with the smaller sized kits) is the standard release for this product. To release the concrete easily from the mold, you can also use motor oil
or castor oil.
AeroMarine's Cement Molding and Stamping Rubber also an excellent choice for making clutch and brake pedals, motor mounts, or door
trim rubber for automobiles. Please call us at 1(877)342-8860 for
advice on how to make a mold for these items.
